Fixtures · Las Vegas and Clark County
Plumbing Fixture Installation In Las Vegas
Most installation call backs are not about the new fixture. They are about the old angle stop underneath it that was reused because it seemed fine. New fixtures get new connections, and anything that has to be reused gets checked properly first.
- Diagnosis before a price
- Nothing extra without your word
- 10 valley communities
The short answer
Fixture installation covers fitting new sinks, tubs, shower valves, hose bibs, ice maker lines and appliance connections. The part that makes an installation last is the part nobody looks at: new shutoffs and new supply lines rather than reusing hardware that is already past its service life.
Is this you?
Signs You Need This
- A remodel or upgrade that needs fixtures connected
- A new appliance that needs a water supply run
- An outdoor hose bib that leaks or will not shut off
- A shower valve that needs replacing rather than repairing
- A sink or vanity change during a bathroom refresh
- An ice maker or filtered water line to a refrigerator
Talk to a plumber
Call For A Quote
Plumbing is quicker to diagnose out loud than in a form. Tell us what is happening and you will get a straight answer on what it usually means and what it costs to find out.
Call Now (725) 444-5979Have these ready
- What failed, or what you can see
- Anything you have already shut off
- Whether the water is clean or waste
- How many fixtures are affected
- The age of the house, if you know it
Office hours Monday to Friday, 8:00 to 17:00. Call to confirm availability outside them.
What is included
What This Service Covers
| Sinks and vanities | Kitchen and bathroom sinks, faucets, drains and traps. |
|---|---|
| Tubs and showers | Valves, trims, drains and diverters. |
| Outdoor | Hose bibs and frost resistant replacements. |
| Appliance connections | Dishwashers, ice makers, washing machines and filtered water lines. |
| Supply hardware | New angle stops and supply lines as part of the installation. |
How it runs
How The Work Goes
- Confirm what is behind the wallValve type, rough in dimensions and what can be reached without opening finish.
- Quote including the hardware most people forgetStops, supplies and trap work stated rather than discovered.
- Install and connectIncluding anything that has to be replaced rather than reused.
- Pressure test and check dryEvery joint checked after it has run under pressure, not just after assembly.
What it costs
What Moves The Price
We do not publish a price list, because a real number depends on what is actually wrong. What we can tell you is exactly what the quote will turn on.
- Whether the rough in matches the new fixture or has to be adapted
- Whether access is open, as in a remodel, or through a finished wall
- How much of the existing supply hardware is serviceable
- Whether a new line has to be run, as with an ice maker or a new hose bib
How the estimate works. The cause gets diagnosed first, then you get the price for the work before it starts. Where repair and replacement are both reasonable, you see both numbers rather than one.
The service call. The diagnostic and callout policy is quoted on the phone before anyone is dispatched, including whether it is credited toward the work. Ask when you call, and you will get a straight answer rather than a figure invented for a web page.
Straight answers
The Questions People Actually Ask
Can you install a fixture I bought online?
Yes. Check the rough in dimensions before you buy, because a valve that does not match what is in the wall is the one problem no installer can solve cheaply.
Do I need new shutoff valves?
If the existing ones are seized, weeping or very old, yes. In this water, angle stops are a wear part, and reusing a bad one is how a new fixture leaks.
Will you have to open the wall?
Only where the valve body requires it. It is confirmed before work starts, so it is never a surprise mid job.
Can you run a line to my refrigerator?
Usually yes, and the route depends on what is accessible. It is looked at before it is quoted.
Where we work
Plumbing Fixture Installation Across The Valley
We cover this service across all the communities below. Each area page describes what we commonly find there.
Questions
Frequently Asked Questions
Do you install customer supplied fixtures?
Yes. Keep all the packaging and hardware until the installation is complete and tested.
What is a rough in dimension?
The spacing of the existing supply and drain connections in the wall or floor. New fixtures have to match it or be adapted, and checking it before buying saves a lot of trouble.
Can you replace a shower valve without opening the wall?
Sometimes, where an access panel exists or the trim allows it. Frequently it needs access, and you are told which before work starts.
Do you handle bathroom remodels?
The plumbing scope, yes: relocating and connecting fixtures, valves and drains. Tile and carpentry are not part of the scope.
Why replace the supply lines on a new install?
Because a braided supply line has a service life and an old one under a new fixture is the weakest part of the installation.
Can you install an outdoor hose bib?
Yes, including replacing one that leaks or will not shut off, which is usually a worn stem rather than a whole fixture.
Need Plumbing Fixture Installation In Las Vegas?
Call (725) 444-5979 for a straight answer, or send a quote request and we will come back to you.